PatrolLink 2.5m Plug & Play Extension Cable

Plug & Play with PatrolLink — or use it as a quick-disconnect harness for custom installations.

The PatrolLink 2.5m Extension Cable adds approximately 8.2 feet of additional cable length between compatible PatrolLink components, giving you flexibility when routing warning lightheads throughout your vehicle.

For a complete PatrolLink installation, simply connect it inline — no cutting, splicing or custom wiring required.

But like the PatrolLink lightheads, you're not limited to a PatrolLink system.

External Flasher & Custom Installations

Building a conventional warning-light system with an external flasher or controller?

The PatrolLink extension cable can be used as a pre-wired quick-disconnect harness. Retain the factory connectors between the lighthead and extension cable, then cut the connector at the controller end to expose the individual wires for connection to your compatible external flasher, controller or switching system.

This gives you the convenience of a removable Plug & Play connection at the lighthead while still allowing conventional wiring at the control end.

Perfect for installations where you may want to easily remove, replace or service a lighthead without cutting wiring.

Features

• 2.5m / 8.2 ft cable length
• PatrolLink Plug & Play compatible
• External flasher compatible when adapted
• Can be used as a quick-disconnect lighthead harness
• Retain Plug & Play connection at the lighthead
• Cut the control-end connector for conventional wiring
• No splicing required between the lighthead and extension
• Individual colour wiring carried through the harness
• Ideal for external flashers and warning-light controllers
• Useful for custom installations and upfitter builds
• Extend existing PatrolLink cable runs
• Patrol Line 3-Year No-BS Warranty

Two Ways to Install

PATROLLINK PLUG & PLAY
Lighthead → Extension Cable → PatrolLink System

EXTERNAL FLASHER / CONTROLLER
Lighthead → Quick-Disconnect Connector → Extension Cable → Cut/Terminate Control End → External Flasher

This allows the same lighthead and cable infrastructure to be used whether you're building a complete PatrolLink system or designing your own conventional warning-light installation.

Plug & Play. External Flasher. Modular.

Build It Your Way.

Be Seen. Be Safe.

Installation Note

When adapting the cable for conventional wiring, cut only the controller-side/end-of-line connector you intend to terminate. Verify individual wire functions before connection to an external controller or flasher.

Cutting a factory connector permanently converts that end of the cable from PatrolLink Plug & Play operation unless a compatible connector is reinstalled.